Paper on eco-driving presented during International Congress Motor Vehicles & Motors 2020

Published on

On 8 and 9 October, the International Congress Motor Vehicles & Motors 2020 will be held virtually. During the conference, Slobodan Mišanović, Project Manager at City Public Transport Company Belgrade will present the paper 'Measurement of recovery electricity on the e-bus higer klq6125gev3 on eko 1 line in belgrade and impact on energy efficiency'.

Alongside his work in Belgrade, Mišanović also is a member of the UITP Bus Committee, where he leads activities on eco-driving.

The abstract of the paper is below. You can find more information about the congress and topics here

One of the most important features of an electric bus (E-bus) is the ability to recovery electricity generated during the braking and deceleration phase of the vehicle. The specificity of bus operation in urban transport is reflected in the dynamic mode of operation of the vehicle, especially in terms of frequency and intensity of acceleration and braking. 

Recovery electricity in the braking and deceleration phase of E-bus is determined by the performance of the drive electric motor, the choice of strategy (algorithm) for regenerative braking control, driving cycle, terrain configuration, the ability of the supercapacitor to receive as much electricity and the driving style of the driver.
The research of electricity recovery on the EKO 1 line on a larger sample of measurements was performed on 25.06.2018, 28.06.2018, 27.09.2018, 08.10.2019 and 09.10.2019. years. The dates were chosen when heating and air-conditioning systems were not used or minimally used only in certain periods of the day, in order to more realistically look at the effect of the achieved recovery and the impact on the energy efficiency of the E-bus. The measured values of the supercapacitor voltage, the discharge and recuperation current of the supercapacitor and the SOC values were taken from the SD memory card  BMS (Battery Management System) of the control unit that performs data acquisition from the V-CAN of the E-bus